RPE-G Pipeline Exterior PE Powder Coating
Product property
The pipeline is coated with thermoplastic polyethylene powder coating, primarily used for external applications in petroleum, natural gas, and water supply/drainage pipelines. Based on linear low-density polyethylene, this coating shows excellent flexibility and resistance to environmental cracking. Appropriate modifying additives are incorporated during production, endowing the product with superior flexibility and bending strength, which enhances its ability to withstand impact loads and protect the coating integrity. Additionally, it demonstrates high heat and low-temperature resistance, making it a corrosion-resistant coating with excellent puncture resistance, tear resistance, and barrier properties.
Product technical specifications and applications
1. Technical function
|
No. |
Test items |
Performance index |
Operative norm |
|
1 |
Powder size |
Remnants on the 60-mesh sieve ≤5% |
GB/T6554-2003 |
|
2 |
Flowability |
The floating rate is ≥20% |
|
|
3 |
Non-volatile content |
>99.9% |
GB/T6554-2003 |
|
4 |
Melt flow index (g/10 min) |
7-11 |
GB/T3682 |
2.Technical Performance of PE Powder Coating Film for Pipeline Corrosion Protection
|
No. |
Test items |
Performance index |
Operative norm |
|
1 |
Coating appearance |
Uniform and smooth |
|
|
2 |
Peel strength N/cm |
≥40 |
GB/T 2792: Liquidity |
|
3 |
Flexural strength 4° |
1 |
|
|
4 |
Impact strength |
≥21.6 |
GB/T1040 |
|
5 |
Low-temperature resistant catalytic property |
≤-65℃ |
GB/T5470 |
|
6 |
Electrical strength MV/m |
30 |
GB/T1408.1 |
|
7 |
Tensile strength MPA |
≥10 |
GB/T1040 |
|
8 |
Elongation at break % |
≥500 |
GB/T1040 |
|
9 |
Chemical-resistant (7 days) 10%HCL 10%NACL 10%NAOH |
≥80 ≥80 ≥80 |
GB/T23257-2017 |
|
10 |
Heat-resistant aging percentage |
≤80 |
GB/T3682 |
| Note : | 1. Resistance to chemical corrosion is measured by the retention rate of tensile strength and elongation at break after testing. | ||
| 2. The heat-resistant aging index is the deviation in fluid flow rate before and after the experiment. | |||
Coating process:
To ensure optimal coating quality on steel pipes, pretreatment is essential to enhance the adhesion between the coating and the steel substrate. Given that large-diameter steel pipes used in such applications feature thick walls and high thermal capacity, the preheating temperature is typically set at 230°C ± 20°C. This temperature allows the pipe's inherent heat to facilitate coating penetration, curing, and leveling. The method is suitable for internally coated fusion-bonded epoxy powder and externally coated polyethylene powder steel pipes; however, the preheating temperature should be adjusted according to wall thickness variations (lowering as wall thickness increases) to maintain uniform coating thickness and achieve effective corrosion protection.







